Export thread

FS 45 Throttle Trigger

#1

H

hffarms

Im working on a weed eater I purchased from a neighbor that hasn't ran in a while. Im trying to reassemble the throttle/trigger components but im having a terrible time figuring out the exact placement of the spring on the trigger. I've attached some photos in hopes of illustrating the problem area. Any suggestions on how this should go would be greatly appreciated!

IMG_0919.JPGIMG_0918.JPGIMG_0917.JPG


#2

B

bertsmobile1

The wires go in the little chanels on the left side of the photo,
When you put the two halves of the handles together pull the trigger and the trigger lock in so the little foot on the bottom of the trigger lock can go under the trigger.
Screw the switch end together loosely then pass the tube through the almost closed handle.
I find it easier to fit the drive cable in the clutch then slip the tube over it.


#3

primerbulb120

primerbulb120

Putting a string trimmer throttle grip back together is one of my least favorite procedures. I hope you get it back together okay!


#4

H

hffarms

Thanks for the help! I was finally able to get it back together. Im hoping its a long while before I have to do that again :laughing:


Top