I have a craftsman koler 14 hp and would like it To go faster im a noob so dont tell me to do too complicated but i know to change pulleys but what about the motor?
I have a craftsman koler 14 hp and would like it To go faster im a noob so dont tell me to do too complicated but i know to change pulleys but what about the motor?
Welcome aboard, glad to see new people here, there is a lot of knowledge that goes through here. You can't go wrong by being on this forum it's a no brainer licking:
I want it to move faster i took the mowing part off. I heard from youtube to take the exhaust right off and change pullies. Can i do much else like the govener i want it to go faster than it is but not so fast it blows the motor
I want it to move faster i took the mowing part off. I heard from youtube to take the exhaust right off and change pullies. Can i do much else like the govener i want it to go faster than it is but not so fast it blows the motor
If you block out the governor you will take a chance of over revving and major engine damage,,,
If you have adequate HP and low end torque, you can change the primary pulley (larger) and the secondary pulley (smaller)...
just like changing the sprocket sizes on a bicycle or a go-cart... :smile:KennyV
