You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Engagement Lever L120
- Thread starter joediyall
- Start date
More options
Export threadbertsmobile1
Lawn Royalty
- Joined
- Nov 29, 2014
- Threads
- 64
- Messages
- 24,729
Look under the dash
The lever that pulls the wire is held to the shaft by a pin
Yours has broken or fallen out
Go to the JD web page and look at the parts diagram for your mower it will show you a lot better than I cah do a word picture here
It is not a very good design as there isa massive shear load on it so no surprise that it shears
I drill them out & fit a bigger roll pin
The lever that pulls the wire is held to the shaft by a pin
Yours has broken or fallen out
Go to the JD web page and look at the parts diagram for your mower it will show you a lot better than I cah do a word picture here
It is not a very good design as there isa massive shear load on it so no surprise that it shears
I drill them out & fit a bigger roll pin
Thank you. The screw is there but the linkage itself is broken. Is just a weak spot. Therefore it is bend down and slides under the bracket. The new ones are more solid and I guess don't break that easy. Thanks again.
bertsmobile1
Lawn Royalty
- Joined
- Nov 29, 2014
- Threads
- 64
- Messages
- 24,729
Oh that is different
Any way is is a fairly easy fix
Any way is is a fairly easy fix