Results 1 to 3 of 3

Thread: PTO clutch problem

  1. #1

    Question PTO clutch problem

    Hi. I am new to the forum, but have a serious question about the electric PTO clutch on my Dad's Cub Cadet 1045. The wire harness going into the clutch has rubbed & broken off too close to the clutch to be able to splice a new wire. It is a Werner Electric # 521979. Is there any other way to repair other than replacing the whole clutch & pulley assembly?

  2. #2

    Re: PTO clutch problem

    Hello & WELCOME to these Forums...

    There will be a plastic block at the end of the wires at the clutch, You may be able to carve enough of it away to solder new leads to that clutch... It is where Werner attached their leads to the coil winding. Be careful and you should be able to do it...
    Otherwise its a major job to replace only the coil.
    Replacing the complete assembly will set you back around $150 +(that clutch is used in a lot of CubCadet & MTD models)... so I would take the shot at attaching new leads... KennyV

  3. #3

    Re: PTO clutch problem

    I moved your thread to the Small Engine & Mower Repair Forum.
    -lawn mower fanatic

    4x6 utility trailer
    Honda HRX217HYA mower---Honda HRR216TDA mower---Craftsman 24" 179cc dual-stage snow blower---Echo SRM-225 trimmer---Echo GT-2100 trimmer---Echo PB-255LN handheld blower---Echo PE-225 edger---Black and Decker 22" electric hedge trimmer

Similar Threads

  1. electric pto clutch.
    By wesk in forum Small Engine & Mower Repair
    Replies: 22
    Last Post: 01-27-2015, 07:06 PM
  2. pto clutch removal
    By dam1914 in forum John Deere Forum
    Replies: 1
    Last Post: 05-14-2012, 02:21 AM
  3. Blades No PTO Clutch
    By Hopper1 in forum Grasshopper Forum
    Replies: 5
    Last Post: 06-11-2011, 09:23 AM
  4. PTO clutch
    By skidder in forum Small Engine & Mower Repair
    Replies: 2
    Last Post: 07-31-2010, 08:54 AM
  5. Cub Cadet i1050 - PTO Clutch Engagement Problem
    By Canada_CT230 in forum Small Engine & Mower Repair
    Replies: 7
    Last Post: 05-12-2010, 11:56 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts