Hi
I have a 10 year old MF ride-on with a Kohler 14 hp engine and it is in good condition and given me many tears of trouble free service - well actually my wife uses it :thumbsup:
However this summer (Australia) it is erratically cutting out due to water in the carbie - normally 10 minutes into the cut. I drain the carbie and away it goes usually completes the job with no problems. I have tried adding Methylated Spirits and tried Acetone.
Eventually I removed the plastic fuel tank, dried it completely, flushed the fuel line, replaced fuel filter, cleaned carbie and replace with new fresh fuel..... it ran fine last week (2 hours) but today 10 minutes it has happened again.
If I am careful removing the bowl you can see the water globules - any ideas where it is coming from and how to solve
I have a 10 year old MF ride-on with a Kohler 14 hp engine and it is in good condition and given me many tears of trouble free service - well actually my wife uses it :thumbsup:
However this summer (Australia) it is erratically cutting out due to water in the carbie - normally 10 minutes into the cut. I drain the carbie and away it goes usually completes the job with no problems. I have tried adding Methylated Spirits and tried Acetone.
Eventually I removed the plastic fuel tank, dried it completely, flushed the fuel line, replaced fuel filter, cleaned carbie and replace with new fresh fuel..... it ran fine last week (2 hours) but today 10 minutes it has happened again.
If I am careful removing the bowl you can see the water globules - any ideas where it is coming from and how to solve