Results 1 to 10 of 10
  1. #1

    Join Date
    Sep 2011
    Posts
    28
    Location
    Virginia
    Mower
    Snapper

    self propelled gear box question

    anyone know how much gear oil the gear box holds on a self propelled snapper push mower?? also i see they sell "00" grease for the tranny? is this the only weight that can be used?

  2.  

  3. #2

    Join Date
    Oct 2011
    Posts
    13
    Location
    Oklahoma
    Mower
    Snapper

    Re: self propelled gear box question

    I've used some Pennzoil 80W-140 gear oil for my Snapper that my Dad had left in his garage.

    I think any good multi-viscosity gear oil like that would be fine. If your mower is still under warranty then go ahead and use the Snapper brand to avoid any issues. pn: 2-9443

    As far as the gear case capacity I don't know but you may be able to find that in your manual. Or, try looking it up on snapper's website. I think they may also have manuals to download.

    It's filled to just the top of the gears so, it might hold a quart at most if I were to guess. I've only topped it off before when I needed to.

    Hope that helps some.

  4. #3

    Join Date
    Oct 2011
    Posts
    13
    Location
    Oklahoma
    Mower
    Snapper

    Re: self propelled gear box question

    Well, in this thread the advice is to not use gear oil:

    http://www.lawnmowerforum.com/snappe...n-leaking.html

    I've never had any problems with it but they're the experts. Go with the Snapper brand recommendation then.

  5. #4

    Join Date
    Oct 2011
    Posts
    37
    Location
    Minnesota
    Mower
    Badboy

    Use 00. Any other will most likely leak

  6. #5

    Join Date
    Sep 2011
    Posts
    172
    Location
    North Carolina
    Mower
    Walker

    Re: self propelled gear box question

    Yes if you use other than oo grease they will weep and leak, the gearbox has enough lube if when you take the cap off the top and roll it back and forth a few times , if the gear you can see is wet with greae it is full. try to find someone that stocks the small bottles, a quart will last you for years, to be honest they rarely even need topping up, mainly have it for the vary rare tear down and repair.
    If a hammer doesn't fix it then you have an electical problem.

  7. #6

    Join Date
    Oct 2011
    Posts
    37
    Location
    Minnesota
    Mower
    Badboy

    I have seen many time though where the grease inside the tranny is dry almost like dirt. When it's like that the bearing doesn't get lubrication and will fall apart and jam up the transmission. Only relaxed the grease if it's dried up otherwise no need to add any

  8. #7
    Snapperfreak's Avatar
    Join Date
    Dec 2011
    Posts
    639
    Location
    California
    Mower
    Snapper

    Re: self propelled gear box question

    i've used snapper 00 grease for the last 15 years with no problem whatsoever. i squirt in about a tablespoon or so into the gearbox as i'm slowly rolling the mower so as to apply grease as the gears ar spinning...just to apply more evenly. i'll check the gearbox at least once a year.

  9. #8
    reynoldston's Avatar
    Join Date
    May 2011
    Posts
    5,121
    Location
    Marion,NY
    Mower
    Ferris, John Deere, Wheel Horse, Toro, Cub Cadet

    Re: self propelled gear box question

    I would say Lubriplate 105. Thick enough not to leak but also thin enough to flow to lube the gears and bearings. This is the lubrication they use in the antique outboard boat motor gears before they use the modern style seals.

  10. #9

    Join Date
    May 2016
    Posts
    2
    Location
    Florida
    Mower
    John Deere

    Re: self propelled gear box question

    Quote Originally Posted by harleyman959798 View Post
    anyone know how much gear oil the gear box holds on a self propelled snapper push mower?? also i see they sell "00" grease for the tranny? is this the only weight that can be used?
    How about that! My first post and I get to actually answer a question? Lol cool.. Anyhow -- In the 'Snapper Parts Manual' for the RP21600-21 SP mower, there is a small blurb at the bottom of the exploded view of the drive system that states "4 oz of 00 Grease"... So there ya go ;). I'm in the midst of restoring (not for show, but for the lawn) a 1996 model, and ran-across that a week or so ago.... As you can see, I've got a real project on my hands, and don't axe me why I'm doing this -- I dunno.
    0101.jpg

  11. #10

    1,000 Post Club
    BlazNT's Avatar
    Join Date
    Apr 2012
    Posts
    2,155
    Location
    Missouri
    Mower
    RZ5424

    Re: self propelled gear box question

    this thread is 4 yrs and 4 months old.
    Chuck
    We Do Not Stop Playing When We Grow Old
    We Grow Old If We Stop Playing

Similar Threads

  1. snapper self propelled electric start question
    By harleyman959798 in forum Snapper Forum
    Replies: 1
    Last Post: 01-17-2012, 07:15 PM
  2. HR215 drive shaft broken - gear box won't let mower back up
    By kc cat in forum Small Engine & Mower Repair
    Replies: 3
    Last Post: 08-31-2011, 03:55 PM
  3. Repairs _ _ _ _ STEERING BOX _ _ _ _
    By Bandito in forum Mower & Equipment Operation
    Replies: 0
    Last Post: 06-24-2011, 05:38 PM
  4. Crazy typing box
    By twall in forum Site Discussion
    Replies: 7
    Last Post: 04-06-2011, 09:33 PM
  5. best box
    By kenmac in forum Mower & Equipment Operation
    Replies: 8
    Last Post: 05-28-2010, 10:49 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •