My mother just moved here from several states away -- the mower was in transit "nose down" when it arrived, and the pull cord had been removed from the holder while the handle was disassembled. A metal clip prevents the cord from retracting into the housing while in the disassembled state.
Put it all together, but had some difficulty pulling the cord the remaining 6" required to nest the handle in the cord holder on the handle. From there, even while depressing the safety/start bar, the crank cord will not pull more than about 1/2 inch which is no where near enough to start.
Ideas?
Put it all together, but had some difficulty pulling the cord the remaining 6" required to nest the handle in the cord holder on the handle. From there, even while depressing the safety/start bar, the crank cord will not pull more than about 1/2 inch which is no where near enough to start.
Ideas?