Davescheetah
Forum Newbie
- Joined
- May 22, 2018
- Threads
- 1
- Messages
- 1
Hi all,
This question has been probably beat to death, but couldnt find a definitive answer.
Brand new scag cheetah 52 owner, never had a zt before.
Getting alot of edge of deck scalping with the deck on the slighest slope. The deck is set about 3 1/2 inches but the front deck rollers barely touch the ground. Should I lower the factory set front wheel positions to the other set of holes so the wheels contact the ground better? My tractors deck used to rely on the deck wheels to follow the ground so not sure if this is correct. The deck measures level side to side and tire press. is correct.
Thanks,
Dave
This question has been probably beat to death, but couldnt find a definitive answer.
Brand new scag cheetah 52 owner, never had a zt before.
Getting alot of edge of deck scalping with the deck on the slighest slope. The deck is set about 3 1/2 inches but the front deck rollers barely touch the ground. Should I lower the factory set front wheel positions to the other set of holes so the wheels contact the ground better? My tractors deck used to rely on the deck wheels to follow the ground so not sure if this is correct. The deck measures level side to side and tire press. is correct.
Thanks,
Dave