Results 1 to 3 of 3
  1. #1

    Join Date
    May 2018
    Posts
    2
    Location
    North Carolina
    Mower
    Dixon

    need help with wiring on a dixon ztr 428 1988

    does anyone have a pic or pics of how the wiring is on the solenoid on a 1988 Dixon ztr 428 . I need this real bad I have had to put 2 armatures on it because something is not right the way I have it wired. would appreaciate all the help I can get. Thanks.

  2.  

  3. #2

    Join Date
    Nov 2014
    Posts
    8,327
    Location
    Australia
    Mower
    Victa slashers & Push , Rover Rancher II's, Cox ( several ) & White LT120 + GT 200

    Re: need help with wiring on a dixon ztr 428 1988

    Dear Mr Tropical fruit.

    1) please refrain from posting in more than one place, it gets very confusing.
    2) please refrain from posting in funny colours, it makes your posts hard to read.
    3) get a copy of the parts break down so you can use correct names for things, it makes it a lot easier if we are all talking about the same things.
    The only armatures that are replaceable on a mower is the one in the starter motor.

    Now stop panicing, you are in good hands here, take a deep breath and tell us EXACTLY what the original problem was and what you did to correct it.

    It is also a lot more helpful if we know which engine is fitted to your Dixon.

    The starter solenoid should have 3 thin wires and 2 thick wires.
    the two thin red wires go on the terminal that is connected to the battery the third ( yellow ) one goes to the small terminal at the base and it is the trigger wire that turns the solenoid on & off.

  4. #3
    LawnWorld Support Catherine's Avatar
    Join Date
    Jun 2015
    Posts
    1,000
    Location
    California
    Mower
    Kubota

    Re: need help with wiring on a dixon ztr 428 1988



    Welcome to the forum. Hopefully, you'll get some answers here
    Catherine
    LawnWorld Support

Similar Threads

  1. Dixon 428
    By rle in forum Small Engine & Mower Repair
    Replies: 1
    Last Post: 09-14-2014, 08:14 AM
  2. Replacing the cone spindle bearings on my Dixon ZTR-428 transaxle
    By smalltownguy2 in forum Husqvarna & Dixon Forum
    Replies: 7
    Last Post: 09-08-2014, 11:33 AM
  3. Help me re-attach my governor spring on my 12HP Dixon 428 ZTR
    By smalltownguy2 in forum Briggs & Stratton Forum
    Replies: 5
    Last Post: 06-03-2014, 03:14 PM
  4. Looking for Dixon ZTR 429 Body & Rear wiring looms
    By jrdettsb in forum Mower & Equipment Buying & Pricing
    Replies: 0
    Last Post: 06-02-2014, 05:41 PM
  5. Repairs Dixon ZTR 429 wiring
    By jrdettsb in forum Husqvarna & Dixon Forum
    Replies: 3
    Last Post: 05-28-2013, 12:28 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •