banjomaniac
Member
- Joined
- Mar 25, 2014
- Threads
- 8
- Messages
- 22
I have a Bolens bl100 line trimmer with a walbro 682 T carburetor it wouldn't start so I took the carburetor apart the diaphragm looked good carb had a little debris on the screen I cleaned it out real good sprayed some air to dry it off make sure all the ports we're open and put it back together. Pumped primer bulb and it fired right up ran for about a minute and then suddenly died then when I pump the primer it would go in but not come back out I took it apart again a little bit of debris but not clogged but I cleaned it up fired right back up, ran a minute or so and same thing again, I've done this three times. I cleaned out the tank but it wasn't bad and I have fresh clean gas. I can pull the carb clean it and the primer bulb will work perfect until I run it then it gets stuck every time.