Husqvarna 48" walk behind model W4814A transmission

ssn

Forum Newbie
Joined
Oct 23, 2017
Threads
1
Messages
1
I have an older Husqvarna model W4814A walk behind that does a fantastic job of cutting; however, second gear does not work properly. First gear runs fine, but second gear jerks like it is missing a gear tooth or something. Reverse doesn't work either. I would like to correct these problems. First gear is a little too slow but third gear a little too fast. In anticipation of a transmission tear down, I've looked for parts but haven't seem to locate them. Perhaps someone might have an entire transmission or repair thoughts.
 

Catherine

LawnWorld Support
Staff member
Joined
Jun 13, 2015
Threads
2
Messages
1,683
:welcome:

Welcome to the forum!
:tractor: I'm going to move this thread over to our Husqvarna section.
 
Top