Who can identify this part found inside a B&S 19.5 engine from a JD LA105
- Thread starter ryszardx
- Start date
Boudreaux In Eunice La.
Lawn Addict
- Joined
- Jul 22, 2017
- Threads
- 21
- Messages
- 2,154
Is there a hole on the end of it ?? It got hit by something for sure. What was the engine doing when you decided to open it up ??
Was the cam in place when you popped the sump off ???
Was the cam in place when you popped the sump off ???
Last edited:
Boudreaux In Eunice La.
Lawn Addict
- Joined
- Jul 22, 2017
- Threads
- 21
- Messages
- 2,154
Almost looks like a valve seal ~!~!
Last edited:
i was going to say valve seal as well. Just guessing without being there
Pulled the crank and it had a hole on the flywheel side!
Connecting rod was gone!
I straightened the cup-like plug and and pushed it in place at the connecting rod end of the crankshaft. Without the plug oil won't reach the flywheel end of the crank. It appears that the way the crank was machined, a plug was necessary. A spring clip like the one holding the crankpin in probably would have been a good idea. This would prevent the plug from popping out like it did.
Boudreaux In Eunice La.
Lawn Addict
- Joined
- Jul 22, 2017
- Threads
- 21
- Messages
- 2,154
When you say connecting rod do you mean the piston rod or the syncro balancer pin/rod ?? Take a couple pics and show them on here.
I am curious to see what happened in there ~!~!
I am curious to see what happened in there ~!~!
