CH12.5S Kohler - Brand New Coil Failure

RTWilliams

Forum Newbie
Joined
Aug 7, 2017
Threads
1
Messages
3
I have a 2135 Cub Cadet (1993 model) with Kohler CH12.5S engine. Finally had to replace original coil recently after about 400hrs. Installed new OEM coil and spark plug to correct air gap, plug gap,etc. Only got about 15-20hrs in before new coil failed. Not sure what my next move should be. Why does a new coil fail? Reluctant to just buy another coil for $60. Engine in great shape otherwise. Any suggestions appreciated. PS. I'm a competent mechanic but a little weak on the electrical side. Thx!
 

cpurvis

Lawn Addict
Joined
Aug 25, 2015
Threads
21
Messages
2,256
How are you testing the coil to determine whether it is good or bad?
 

Catherine

LawnWorld Support
Staff member
Joined
Jun 13, 2015
Threads
2
Messages
1,683
:welcome:

Welcome to the forum!

I'm going to move this thread over to our Cub Cadet section. :smile:
 

EngineMan

Lawn Addict
Joined
Jun 12, 2012
Threads
9
Messages
2,275
Even news ones go bad, test it, replace it and try again.
 

Attachments

  • Screenshot_1.jpg
    Screenshot_1.jpg
    92.6 KB · Views: 14

RTWilliams

Forum Newbie
Joined
Aug 7, 2017
Threads
1
Messages
3
How are you testing the coil to determine whether it is good or bad?

I troubleshooter the old one while it was still on the mower by verifying that the spark was weak. After I put a new oem coil and plug in it, ran great for a while then acted same exact way when it failed. What's the best way to test one after it's off the tractor? thx
 

bertsmobile1

Lawn Royalty
Joined
Nov 29, 2014
Threads
64
Messages
24,702
Cheap & nasty test is to pull off the kill wire and then try starting the engine.
The kill wire is a ground wire and as it runs across the fins they easily rub through the insulation thus earth out all over the place.
 
Top