RedneckPapaman
Forum Newbie
- Joined
- Aug 22, 2017
- Threads
- 3
- Messages
- 7
Sure need some help! I replaced the drive belt that was cut in two an additional 2 times and both broke! I read the forum, studied the parts manual for belt routing and watched a few videos on YouTube and decided that I had installed the belt incorrectly! So I purchased another belt and the idler pulley and replaced them both. Pretty sure they were on correctly since I started the mower and cut the grass in the back yard for about 30 minutes but right before finishing up the belt came off again!! I had purchased the 2 pulley's with the plastic fans that mount on the top of the transmission but couldnt figure out how to get the old ones off without dropping the transmission. Is there any way to take them off without dropping the transmissions on both sides? Thanks