Spacing spindles with washers?

whitepony04

Member
Joined
Jul 4, 2017
Threads
2
Messages
15
Star hole. I didn't impact the nuts. Whole mower only has 6 hrs on it so no beatings replaced.
 

bertsmobile1

Lawn Royalty
Joined
Nov 29, 2014
Threads
64
Messages
24,647
How far are the blades out ?
Did you try swapping the blades ?
Is the nut on the top of the spindle tight ?

This is a bit on the weird side
 

whitepony04

Member
Joined
Jul 4, 2017
Threads
2
Messages
15
There was about an 1/8" difference. I can check the spindle nut tomorrow and give an update.
 

TJR345

Member
Joined
Aug 10, 2017
Threads
0
Messages
48
There was about an 1/8" difference. I can check the spindle nut tomorrow and give an update.

When you measure the blades for level first be sure tires are properly inflated.Next turn the blade so they are side to side.That should be level on both blades (3" for example) Then turn so they face front to back.The front facing blade should be 1/8 to 1/4 lower.
 

whitepony04

Member
Joined
Jul 4, 2017
Threads
2
Messages
15
As of right now, everything is tight, blades are within a 1/16 of each under in the center of the deck and side to side the deck is level. Also the front of the deck is about 1/4 lower than the rear.

This is all with the washers installed.
 

whitepony04

Member
Joined
Jul 4, 2017
Threads
2
Messages
15
Update: just finished the yard and the cut is better than it's ever been. I rechecked the spindle bolts and they are still tight. Should I lock-tite them?
 
Top