How complete is the Briggs repair manual?

Hello all, I am working on my daughters JD 135. It has a 22HP vert shaft Briggs. Took the carb off to clean. Found two jets on the work bench after spraying carb out. Do you know if the Briggs manual is detailed enough to show the orientation of these jets? I think they go in the bottom right above the float bowl but not sure. And not sure of the up/down orientation. Any help will be appreciated...........Jay

No the briggs manual assumes you have been to the Briggs training school and are a trained mechanic.
If there is a step in the outside of the jet, the smaller diameter goes in first
If the hole has a chamfer then that will go on the float bowl side ( fuel passes in there first )
If this is a double barrel carb, the jets might be different sizes.

We need the full engine number to give you specific advice.
Model, code & serial because carbs & jets change very regularly

This site is aimed at the handyman ( sexist bugger ain't I ) level.
http://outdoorpowerinfo.com/repairs/briggs_intek_v-twin_carb.asp

OK Thank You Will go to that other site But:

On right valve cover
Model 407777

Type 0232 B1

Code 090526YG

And on flywheel shroud

GXA135A300748

This is a Lowes mower not a real John Deere also. Thanks for the help..............Jay

Thanks to that other site I think its OK. One problem, I lost the tiny nylon bushing the governor rod goes through. Any ideas where I can get some?? Thanks..............Jay