Results 1 to 2 of 2
  1. #1

    Join Date
    Apr 2017
    Posts
    2
    Location
    Virginia
    Mower
    John Deere

    JD lt180 grinding noise when forward

    Hi all,

    Have a John Deere lt180 automatic with 42" freedom cut deck. Has about 200 hours on it. Yesterday mowing as usual and all of a sudden a grinding noise started underneath the seat. It happens each time I press the forward pedal and I don't think I would move forward much at all if any. I was worried I would do further damage so shut it down and pushed into barn. It doesn't happen when pushing the reverse pedal. I can go backwards it seems ok. Also, when I push the clutch pedal in on right side (pedal pushed when starting mower) the grinding noise happens but will stop if let that pedal go back to its rest position.

    Any ideas?
    Thanks'

  2.  

  3. #2

    Join Date
    Mar 2012
    Posts
    6,948
    Location
    Wisconsin
    Mower
    Toro

    Re: JD lt180 grinding noise when forward

    Remove the deck and take a good look at the drive belt and tensioner pulleys. My bet is a bad pulley, but I would replace the belt at the same time.
    This is only my opinion, and many will say it ain't worth a darn, as I'm only a retired grease monkey instructor and not a professional mechanic. Use what I post at your own risk as you know teachers only know book knowledge.

Similar Threads

  1. 2014 FW35 -- HELP, Grinding noise when in neutral
    By BillinPA in forum Ferris Forum
    Replies: 1
    Last Post: 12-30-2015, 07:12 PM
  2. HRX217HYA with grinding noise
    By Joeyg023 in forum Honda Forum
    Replies: 16
    Last Post: 03-18-2014, 12:41 PM
  3. John Deere LA125 problems! Grinding noise? HELP!
    By musc in forum Small Engine & Mower Repair
    Replies: 1
    Last Post: 07-25-2013, 10:50 PM
  4. Pull cord too short? Grinding noise.
    By supaphly42 in forum Small Engine & Mower Repair
    Replies: 5
    Last Post: 06-18-2013, 05:54 PM
  5. Craftsman Mower grinding noise
    By ddzamba in forum Small Engine & Mower Repair
    Replies: 5
    Last Post: 03-02-2012, 04:33 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •