Hi I hope someone can help..
I have a Poulan PP19A42 7 months old, not much used, all was working well until she slowed to a halt.. no drive
On inspection right at the rear of the machine there's a mechanism that raises the lower half of a pulley to adjust the variable speed.. the bottom part of this had melted
Whatever used to act a bearing that put pressure on the lower pully half was gone and the base that held it was deeply grooved and melted..
In the manual there are no part numbers for this, its all shown as a complete rear drive unit.. the only reference I can find is drive-tex VATR PEDAL 33...
Anyone any ideas how to source these parts ?
Thanks
Steve
I have a Poulan PP19A42 7 months old, not much used, all was working well until she slowed to a halt.. no drive
On inspection right at the rear of the machine there's a mechanism that raises the lower half of a pulley to adjust the variable speed.. the bottom part of this had melted
Whatever used to act a bearing that put pressure on the lower pully half was gone and the base that held it was deeply grooved and melted..
In the manual there are no part numbers for this, its all shown as a complete rear drive unit.. the only reference I can find is drive-tex VATR PEDAL 33...
Anyone any ideas how to source these parts ?
Thanks
Steve