Hi guys. I'm fairly new to this forum. I have read some about surging and running lean engines. I guess when you say drill a nozzle or a jet you drill down into
the jet, opening the hole a little bigger. Do you ever drill out the little holes that run cross ways in the jet? Also do you just take your next bigger micro drill bit
than the one that will fit into the hole? One more thing, do you ever git little pieces of metal down in the jets? Will spraying with carb cleaner and blowing it out
with compressed air clean them out good? I was thinking about helping a friend with a surging Duraforce. Thanks in advance for any helpful hints.
Jerry
the jet, opening the hole a little bigger. Do you ever drill out the little holes that run cross ways in the jet? Also do you just take your next bigger micro drill bit
than the one that will fit into the hole? One more thing, do you ever git little pieces of metal down in the jets? Will spraying with carb cleaner and blowing it out
with compressed air clean them out good? I was thinking about helping a friend with a surging Duraforce. Thanks in advance for any helpful hints.
Jerry