1st post, glad to be here! Hoping you guys can help me out.
Lawn size: Just under an acre (0.7). 31,000 sq ft. (Actual lawn area)
Mower: John Deere LA115 42", 2-blade mower deck.
New Blades
Looking out the front door, my lawn slopes to the right.
If I'm mowing up/down the slope and when I'm mowing left to right against the slope (its not too steep), I'm getting blade cuts deeper on one side.
However, this doesn't seem to be an issue on the part of the lawn that is fairly flat.
Note: The lawn is not perfectly/professionally leveled, so it has its imperfections.
I know my mower deck is level, but I'm wondering about the wheels on the front left/rigth of the deck. They're typically off the ground, but I believe this is correct.
I'm wondering if I need to do some adjusting to these, or if its just the nature of s somewhat bumpy lawn?
Any suggestions?
In this 1st shot you can see the slope of the lawn. Cuts are pretty good until you get to the slope.
![FullSizeRender 2.jpg FullSizeRender 2.jpg](https://www.lawnmowerforum.com/data/attachments/22/22445-3d7685a137212b7a19c5982bbfa14e93.jpg)
Another shot of the cuts on the side as I start going perpendicular to the slope
![FullSizeRender 3.jpg FullSizeRender 3.jpg](https://www.lawnmowerforum.com/data/attachments/22/22456-7f3e9f5746e9fecec2e7e1dbd068be8b.jpg)
A pretty deep cut
![FullSizeRender.jpg FullSizeRender.jpg](https://www.lawnmowerforum.com/data/attachments/22/22464-e91287e16fd6a0e4c0ca2148a03e98f4.jpg)
Lawn size: Just under an acre (0.7). 31,000 sq ft. (Actual lawn area)
Mower: John Deere LA115 42", 2-blade mower deck.
New Blades
Looking out the front door, my lawn slopes to the right.
If I'm mowing up/down the slope and when I'm mowing left to right against the slope (its not too steep), I'm getting blade cuts deeper on one side.
However, this doesn't seem to be an issue on the part of the lawn that is fairly flat.
Note: The lawn is not perfectly/professionally leveled, so it has its imperfections.
I know my mower deck is level, but I'm wondering about the wheels on the front left/rigth of the deck. They're typically off the ground, but I believe this is correct.
I'm wondering if I need to do some adjusting to these, or if its just the nature of s somewhat bumpy lawn?
Any suggestions?
In this 1st shot you can see the slope of the lawn. Cuts are pretty good until you get to the slope.
![FullSizeRender 2.jpg FullSizeRender 2.jpg](https://www.lawnmowerforum.com/data/attachments/22/22445-3d7685a137212b7a19c5982bbfa14e93.jpg)
Another shot of the cuts on the side as I start going perpendicular to the slope
![FullSizeRender 3.jpg FullSizeRender 3.jpg](https://www.lawnmowerforum.com/data/attachments/22/22456-7f3e9f5746e9fecec2e7e1dbd068be8b.jpg)
A pretty deep cut
![FullSizeRender.jpg FullSizeRender.jpg](https://www.lawnmowerforum.com/data/attachments/22/22464-e91287e16fd6a0e4c0ca2148a03e98f4.jpg)