funflyer
Member
- Joined
- May 1, 2016
- Threads
- 5
- Messages
- 21
Have any of you guys tried one? I was thinking of testing one to see how much of a difference it could make on actual oil temps. The one in the picture is supposed to have a 3" ID and the oil filter on a Kohler mic'd at 2.8". The two bolts they have to hold it on seem kind of cheezy and might cause more problems so I figured I would split the heatsink (yellow line) and tap for two screws (red lines) so the unit can be snugged up completely around the filter. Couldn't hurt, right?