Mine are loose, because I think the nuts have been tightened up too much.
this saw has a plastic housing, into which the studs disappear. I cant tell how or what they are embedded into, but I can see there are splines on them. I hammered them back in, but they just came loose again. Also when i hammered them in, one turns with the nut, which kind of suggests it has lost its anchoring in the body.
IPLs dont even show these studs so i cant see what they screw into exactly.
you cant tighten the bar properly anymore now, So can this be fixed, or is the saw a throw away now?
this saw has a plastic housing, into which the studs disappear. I cant tell how or what they are embedded into, but I can see there are splines on them. I hammered them back in, but they just came loose again. Also when i hammered them in, one turns with the nut, which kind of suggests it has lost its anchoring in the body.
IPLs dont even show these studs so i cant see what they screw into exactly.
you cant tighten the bar properly anymore now, So can this be fixed, or is the saw a throw away now?