I'm working on a Briggs 15.5HP OHV engine on a Bolens 38" Rider. It turns over and is getting fuel but won't start. I put a tester between the plug and plug wire and it isn't firing. It's got a brand new plug in it. Could this be the coil around the flywheel or is there anything else I need to look at/test to check the problem? It also sounds like it may also have a blown head gasket (poofs when turning over) but I don't think that would keep it from firing. I'm not as familiar with OHV engines which is why I'm asking.
It sat up and got gas in the crankcase/head which I have drained and let air out. I rebuilt the carb and have it right per the lawnmower repair shop I get parts from when needed. It's got a hot battery (just charged it over night) so I can't figure out anything else. It's my mother-in-laws mower and it ran when put up last fall. I desperately need it running...
It sat up and got gas in the crankcase/head which I have drained and let air out. I rebuilt the carb and have it right per the lawnmower repair shop I get parts from when needed. It's got a hot battery (just charged it over night) so I can't figure out anything else. It's my mother-in-laws mower and it ran when put up last fall. I desperately need it running...