I have a 05 Wildcat with a 61" deck. This year the blade belt jumps off "sometimes" when I engage the blades. It is especially bad when the rpm is low. Mower, blades run fine when the belt stays on.
Here's what I have done so far.
Changed idler spring
Changed blades and belt
Bearings get greased regular and have oiled all 3 additional pulleys.
Under deck has been cleaned.
Checked level on deck.
I changed out my clutch last year and gap was good. Any ideas. The blade spindles spin smooth, could it be one of the pulleys, they appear and sound o.k.
Here's what I have done so far.
Changed idler spring
Changed blades and belt
Bearings get greased regular and have oiled all 3 additional pulleys.
Under deck has been cleaned.
Checked level on deck.
I changed out my clutch last year and gap was good. Any ideas. The blade spindles spin smooth, could it be one of the pulleys, they appear and sound o.k.