Search results

Has anyone ever tried to repair a broken/corroded battery terminal on a Toro 106-8397 battery in a Recycler walk-behind mower? Over the years I‘ve had several corrode off because the dirt, clippings and moisture build up in that little compartment. It ticks me off because the batteries haven’t...

No is correct. They probably hooked them there to go through the factory paint booth.

Personally, I've never had long term success with rebuilt engines, but your mileage may vary. I've got a JD 318 and did a 23 Hp B&S Vanguard engine swap a couple of year ago. Bought the kit from Small Engine Warehouse. It's basically a bolt-in swap, with the throttle & choke cable routing...

FWIW - my old Kohler K321 single cylinder engine with cast iron block & heads has 3/8" x 2.5" head bolts, and the recommended torque specs for that is 25-30 Lb/Ft = 300-360 Lb/In.

Horizontal shaft, 23.0 Hp Vanguard engine, model 386447-3079-G1, equipped with (according to the Service Manual) a Nikki carburetor. 1. What is the proper initial setting of the Idle Mixture Screw? My service manual says the initial settings on the Idle Mixture Screws should be 3/4 of a turn...

Is there any way to check the timing of a 23.0 Hp Vanguard model 386447-3079-G1 engine using a 12V powered timing light? I understand the timing can’t be adjusted, but I was hoping the timing could be tested to determine if the flywheel key may be partially sheared. Last fall I installed the...