Search results

Recently lost ground belt on Z248f mower. Belt replaced but now mower has a hard time moving. A little better in reverse but not much. No noticeable problem before belt was lost. Belt is tight and is not slipping on drive pulley. Are there any adjustments I am missing? Hope to hear from...

/What adhesive works best to glue on a new seat cushion?

I recently acquired a zero turn 248f. It has a weak battery so decided to replace with new. It looks to me like a major operation to get battery out! Does all linkage for drive clutches have to be disconnected? what am I missing?

Can the Hydro-gear transaxle #336-0510 be repaired? It chatters loudly but decreases proportionality when pedal is depressed.

ISO pt# 336-0510. I would like to locate and purchase if you have a used one at reasonable cost.

I just acquired an older (she said 1969) Sears (may be David Bradley) 8HP garden tractor. Tractor starts on 1st pull (rope start) and idles down real good and smooth. I need to find information if possible on this tractor. I want to dis-assemble and paint, paint and install mower deck. I can...

A neighbor gave me this unit. Has a Kawasaki engine that he said just quit one day and appears to be locked up. sorta. When starter engages, engine moves slightly then stops, like something is in the way. I may try to repair it, or might just do an engine swap. Any guesses what this could...

I am stumped! 22HP verticle B&S engine is very hard to spin. Had it in shop for oil pan seal, changed crank seal while at it. Shop said it was very hard to start and replaced starter. went to pick it up and shop said engine is very hard to turn by hand. I can't say it is any harder than...

Craftsman 18.5 42" cut Model 917.276750. My neighbor's mower and won't engage mower belt. Engage lever moves freely. Removed lever and bracket to get better look and it seems something has slipped or either cable is too long connecting engage lever to mower deck. Cable is held in place...

I have 4000LT with a peculiar problem. It starts and runs perfectly, for ever and ever; that is until I disengage the mower blades. Then engine dies like fuel has been shut off. It will restart but then dies again and won't restart until it sits for a bit. I purchased this mower for an...

My GT2254 tractor began cranking slow last fall. When engaging, the starter would hesitate a few seconds before cranking engine. I assumed the battery was getting bad because of it's age. I began yesterday getting ready for plowing garden and had to charge battery but it would only go to...

Yesterday when mowing with 247.288820 rider I experienced a starting problem. My starter will not engage. I can hear the solenoid clicking but nothing at starter. I ran hot wire to starter and nothing happened. After towing to garage the starter was removed to bench where I again supplied...

Today I started my saw and used about 1/2 tank cutting grape vines down. I refueled and added chain oil and then saw wouldn't start. After many attempts I removed the spark plug and held the wire wile pulling start rope. Nothing. I stuck metal into the clip thinking there wasn't good contact...

My limb trimmer was running very rough so I installed a carb kit. Never having done this before I wasn't comfortable with my repair so purchased a new carb. After this I haven't been able to start the trimmer. Have spark at plug and new fuel mix. Switched the fuel tubes several times but...

Is it worth trying to rebuild a non manual transmission or just replace the whole rear end?

Having trouble with starter not engaging. I replaced the solenoid and same problem. Not knowing how to troubleshoot, this is what I have done 1) changed solenoid 2) cleaned connections, ground, solenoid to starter. 3) Cleaned Battery to solenoid. 4) cleaned two smaller post and connections...