Search results

One other thing that will lighten up what you’ve got dramatically is by putting a set of those 3/4”:flat bearings and couple wide washers for your wheels to pivot on. I got 4 sets off of eBay in the spring for like $8.50 . I did a bit of shaming to get all a slop out, but the difference it...

I certainly do intend to swap out that entire fuel line. When I pulled the bowl that was spotless 2 weeks ago and found a few specks of blackish spuge in there. Definitely looks like the inside of fuel line probably from the far side of the new mini filter I’d stuck on there and changed a...

With that carb bowl solenoid does it fail intermittently Sometimes? My engine is is surging steadily , doesn’t react to we 40 around the manifold and does shut off when the solenoid plug is pulled Ect. whats the typical lifespan of the fuel pump, mine has 380 hours . ive had mine apart...

Interesting. The debris from the 1 st adventure was looking more like cuttings crud all pulpy and a lot of it. The second time it was clean under that cover plate just a slight difference in the visible opening of one of the main jets that got blown out easily. I’ll give it a try. My...

This is on a 2016 Simplicity Regent 48”mower . 300 hours. Last year it started surging so I followed a pictorial and yanked the carb. The fuel rail under the chrome plate was full of solids gunk. I cleaned it out and checked the needle and sear cleaning everything up with spray carb...

go so far around that the one on the side I’m turning will go sideways enough to stop turning and slide sideways. I just had to put it up in the air because a mixture of grease and grass jammed it to the point that it made steering extremely hard. So here it is cleaned up . No issues with the...

Does that look to be too much too far. I did the grass again yesterday and going around a bush it ended up pushing the right wheel sideways again in spite of my being careful and ready for it. Another question , I see you say to grease the sector to shaft gear on the steering shaft...

Yea weird someone complaining about a too tight turning radius right? Well my 2014 Regent 48” fabricated deck mower actually does. I always noticed it seemed to steer too far in each direction. Not a problem if you go very slow in the turn but if your going down a hill and turn a tad...

Its our old beater 2011 21 inch pusher used for trimming the horrid places ect and it died for no reason besides changing the oil and removing the blade to sharpen it. It ran fine 15 minutes earlier and has been used recently. So when I put it back running it just kicks and backfires...

Machine is new to mi in 14 has under 50 hours. The belt was replaced this summer when my daughter broke it long with bending the steering arm. Of course nobody knows how. Must have been me before I left and fogot:thumbsup: all about it! Yea right. I figure somebody took a sharp turn...