Search results

I have a briggs and stratton horizontal 8hp model 12t102 0060 f8 that is on a little wonder ground blower that was leaking oil. I took it apart replace the the seal and side cover gasket. Put it back together and now it only runs at low rpms full throttle. It seems it's runnng half it speed. The...

I took the engine apart, and the tappets are the same size as the replacement ones. You would think they would make a longer tappet to compensate the push rod size. Is this going to work with a shorter push rod? what should I do?

I have a Briggs and Stratton ohv 8hp i/c Intek engine. These engines are well known for the valve seat falls out on exhaust side of the head, which results in a bent push rod. The engine info is; model 202412 type 0145e1. The push rod part number is 592673. The problem is the original push rod...

I have a Honda hs70 with a g300 engine serial 1328447. Does anyone know the thread size to the petcock of a honda g300 that attaches to the tank?

I have a red max ebz7500 backpack blower. The carb is a walbro wya64b. I cleaned the carb out, rebuilt it, replace the fuel lines, and fuel filter. It's not getting gas. As I pump the primer, I get nothing. But if I tilt the tank towards the l larger diameter line that's suppose to be the return...

I have a Craftsman ohv 179cc snow thrower that surges. I've taken the head off, lapped the valves, new head gasket, cleaned the carb. The carb is a Huayi hy-27. It starts up great but surges. Is it a air leak or bad carb? What should I do?

I bought a Shindaiwa eb-45 back pack blower used and It looks like a home owner hardly used it. Even though it's a older unit, the compression is very strong..I got it running then it started to flood the engine. I removed the spark plug and turned it upside down drained the fuel out of the...

I've rebuild many carbs before, but never had a problem like this. I took carb apart cleaned it, rebuilt it, new needle and seat, seals, float. I adjusted the float, put it all back together and stills have a slow leak. I've read about ethanol eating rubber and aluminum away, so I replaced the...