Search results

HRX217HXA maga 1611616 transmission trouble. Mower will only jerkily move forward very slowly in the highest speed setting and has a grinding sound, not loud but present. The drive cable is in good shape both ends (all the cables are good). The drive belt belt is working correctly. All pulleys...

Hello I have a mower with a B&S 21.5 v twin 407777 0128 e1. About a month ago it started to load up the engine, almost as if it were chocked, while cutting tall grass, spewing black smoke. I throttled it back and it when back to normal. finished cutting without further troubles. Since then it...

McCulloch leaf blower model " MAC 320BV" or 320BV. (blower vac). On the engine their is a label " C134" along with "CT M 32cc SMH032UB24RA EM". I have no idea who made the engine!! The engine starts right up runs as if it is flooding, then after about 1 minute, floods and wont start again...

Honda tiller FG1100K1AT with GX25 engine. 4 cycle miniature tiller on the line of a mantis tiller, a very good machine! The problem is that oil comes out of breather tube into carburetor intake while engine is running. It saturates the breather element and drips out the bottom onto the tiller...

Toro 38180 sn# 0014124 Suzuki 47pk9 engine with original Mikuni carburetor. 1990 model. a ccr2000 unit. This machine had bad gas left in over the summer and was completely plugged come winter. It was taken apart and cleaned in a heated ultrasonic cleaner multiple times to get it cleaned out...

I have an older MTD rider with a standard bagger system on a 38 inch mowing deck and a 12.5 hp briggs engine. It has plenty of power to do the job, but often in a little longer grass or going a little too fast or a little moister on the ground, the chute clogs. I'm looking for a blade that...

I've just been through quit an ordeal with a RZ4216 using a manual pto lever. I didn't have access to a schematic for it, although their is one in the owners manual for the electric pto, but it is much different than what I found from the wiring. To my surprise, it doesn't even have a fuse! I'm...

16.5 hp single cylinder vertical OHV 3100 series Briggs & stratton on a Husqvarna zero turn mower. 31E877 1502-G1 The engine is burning a lot of oil, about 1/4 cup every 2 hours. No oil leaks. The plug is continually fouled, and is cleaned often. It has run ok in the past, but now it is starting...

this mower will blow a fuse each time the pto is engaged. I started testing the pto switch and it test just as described in the wiring schematic. I disconnected the pto connector and ohme'd it at 3.2 ohms. then tested it with an external battery. It engages and disengages normally and draw...

I have a troy built tiller with BS engine 135292-1158-e1. It hasn't been used that much but doesn't run well at all. Hard to start, then runs only with chock partially on and only at high speed. Will not idle. Seems as though it is starving for fuel. Worked well in the past. I took the pulsa jet...

Before I started this project, all worked well with the primer. It would draw from the gas tank, fill the bulb and discharge back to the tank with ease. The engine would start, but would only run with the chock 3/4 engaged, then not at all as it heated up. There are no adjustments on the...

B.S. Engine 128m02-1612-f1-12041958 DOM Apr 2012 190 cc Platinum 7.25 on a 22" walk behind mower I've worked on a lot of engines, but this ones got me stumped! This engine has a very weak spark when started with starter rope. With a neon tester connected to the spark plug, it barely glow...