Search results

Results 1 to 6 of 6
  1. M

    Low power after tune-up

    I have an Exmark zero-turn with Kawasaki FX801V engine. Brought it in the garage last fall, all was running perfectly. This winter I changed the oil and filter, fuel filter and the rocker cover gaskets because they were leaking a bit. While I had those off I figured I would check/set the valve...
  2. M

    Cub Cadet LTX1050VT - broken deck skirt welded on, how to fix?

    Wife was mowing tonight and mower died with a terrible sound. The skirt or brace, whatever it's called, that spans the discharge side of the deck broke loose at the front and got clobbered by the blade. The stamped part is totally trashed, I can't save it. It was welded on, I cut it off with...
  3. M

    Cub Cadet LTX1050VT not charging

    Wife went to start tractor this afternoon, no go. Checked battery, 11.8v or something. Jumped it to start, 10.something across terminals. So the ignition/headlights are pulling it even lower while running, obviously not getting anything from the charging circuit. New battery as of last...
  4. M

    Ryobi trimmer hard to re-start when hot

    Trimmer is 3-4 years old, in springtime I replaced the intake strainer and fuel lines. Starts easy when cold, runs fine. After I use it a bit I notice the throttle gets a little touchy, idles fine but when you apply power you have to kind of nurse it back up to full power. If you stop for some...
  5. M

    Rear tiller for CC LTX1050VT?

    Looked on their website, nothing about tillers for the lawn/garden tractors. Anyone fitted a small tiller from another manf. to this tractor?
  6. M

    B & S gas tank replacement

    Anyone on here own a pushmower with B&S engine, that has had the fuel tank split? I have done some internet searching and apparently it is a fairly common issue. I would have expected to see some kind of recall, with as much emphasis they are putting on environmental issues (i.e. no-leak fuel...
Top