Search results

I have been using my EGO 42" ZT4204L ZTR mower while my 62" Gizmow was in the shop. It's been working surprisingly well for mowing about 7 acres, and I'm thinking that if I move up to the 51 ZT5207L, then I might be able to retire the Gizmow to mowing just the back side of my dam and trails...

When I got the mower back from the shop after the spindle replacement, I mowed a couple of acres when all of a sudden the blades stopped turning. The deck belt was fine. When I tried pulling the PTO switch, nothing happened--not even a click. When I got it to the garage, I noticed that the...

I have an EGO Z6 42" ztr with 4 10 AH batteries. I had thought about adding two more 10 AH batteries, but I noticed that EGO now has a 12 AH battery. Two questions: First, will the 12 AH battery fit and work in the 42" mower? Second, are the mower and charger electronics smart enough to...

One of the spindles on my 11-year-old Gizmow ZTR has finally gone bad. The Gizmow part number is H18056. A similar appearing Great Dane spindle is Oregon 82-328, but it has a spline pulley attachment instead of the key on my Gizmow. That would require replacing the pulleys. Does anyone have...

I have had a Gizmow 61" ZTR for about 10 years with no problems until now. The center spindle has finally gone bad, and I need to try to find a replacement. The Gizmow part number for the spindle assembly is H18055. Someone suggested that a Great Dane spindle might work. My spindle looks very...

I am looking for a battery ZTR mower that I can use to cut the 2 acres around the house and perhaps even occasionally use for the rest of my 7 acres over several days. I am thinking about the Ego Z6 42" ZTR at $4999 and the Ryobi 58" ZTR for about the same price. Ryobi also has some smaller...

I have a Gizmow zero turn mower that uses a steering wheel instead of the typical levers to control the rear wheels. Forward and reverse are controlled with foot pedals--just like on a regular hydrostatic drive tractor (first image). When the mower was new, the mower would be totally stopped if...

I have had a Gizmow 61" ZTR for a little more than 10 years, and I love it. It's fast and powerful, works great with mulching blades and a mulching plate, and it's very stable on the sloping back of my dam. If they started making them again, I would buy another one in a heartbeat. But it is...

In the past, I think we discussed glasses and goggles to reduce the dust in our eyes while mowing. My Gizmow mower does a bang-up job mulching--making the clippings virtually disappear if I mow clockwise and overlap a little. But it really kicks up a lot of dust in the process--especially when...

I need to lubricate the three chains used to connect the steering wheel with the front wheels on my Gizmow Formula ZTR. Two of the chains are located where they are exposed to grass clippings, and I figure I should avoid any regular sticky lubricant. The manual just says "Lubricate the chain...

My Gizmow mower has deck spindle covers held in place by four knobs with 3/8 threads. They tend to vibrate loose, and today when I looked, I only had one left in place. I remember once before I ordered some spares from a general farm supply catalog, but can't remember where. This image shows...

I sure could use some help in getting a new belt installed for the hydro pumps on my Gizmow ZTR. The belt goes over the front engine pulley and the two pump pulleys. I did jury rig a tire tool to pull the tensioner pulley out of the way, but I still can't get the third pulley started. I tried...

I am trying to get my old Troy-Bilt Model 609 42" mower going again. I quit using it several years ago because the PTO belt would not engage properly even with a new belt. When I check the belt tension, it doesn't seem to tighten much at all when I engage the manual PTO. I'm getting ready to...