Search results

I have a Poulan leaf blower that started giving me problems, I replaced the carb, fuel lines and filter and it ran great for 2 days then wouldn't start unless I put fuel in either the cyld. or the carb but only runs till that gas is used. The primer bulb went down when I tried to prime the...

I got my leaf blower out and had it running a couple days ago, at first it would just barely idle until I cleaned out the Muffler (Spark Arrester ) after that it worked great, I ran a tank of fuel thru it and then it started running bad, wouldn't run unless it was on full choke and wouldn't rev...

I have an older model Riding mower ( 917252500 ) and would like to get a snow plow for it so I don't have to shovel snow this year, we had a record amount last winter, I just don't know which plow will work for it. If anyone knows what model plow it takes I would appreciate the info. I have...

My old Craftsman II had a rusted out pulley on the trans-axle so I replaced it and now have other problems, it is making a kind of grinding noise while in gear which it did not do before, it then acts like it has lost power then jerks ahead. It was dark out when I was putting it back together...

I have an older model riding mower and the rear drive pulley needs to be replaced, I bought a new pulley and removed the retaining ring but the outer part of the pulley rusted off the shaft and came loose when I tried to see if it would just pull off, it didn't. There is a piece that is not...

My old motor died so I got a used 17hp Briggs and put it on my tractor, I got it wired and it fired right up but after running for a few mins. it started blowing out white smoke and died, it started back up but then started blowing smoke again........what should I check on the motor? It was dark...

My Craftsman 2 mower died so I took the 13 HP engine off and installed a 17HP motor, they both are briggs motors but the old one had just 3 wires and the new one has 4 wires, I matched up the red and orange wires and got the motor to fire but I still have a black and a grey wire that go to the...

My Craftsman mower had a 13HP Briggs 28m707 motor and I have a briggs 310707 17hp motor I would like to put on it, the old motor blew up and oil poured from it so there is no fixing it. The wiring is similar but different, can someone tell me what wires need to be hooked up so it can run and...