Recent content by rossfrank

  1. R

    Possible death of a tranny

    does anyone know if the 9/16" nut is 18 thread per inch? I have to run a die over it.
  2. R

    Possible death of a tranny

  3. R

    Possible death of a tranny

    Thanks for all the feedback guys. I ended up having to cut the nut off. Pulley has a hole in it about I don't know an inch round it's pretty much shot. Still hoping the tranny's okay. Fish, I have the tractor in gear now that the pulley and everything's off. I could still spin the spindle the...
  4. R

    Possible death of a tranny

    Bolens 38" 6 speed model 13AM 762 F 765. The pulley on the transmission loosend up and sheard the star shaped holders off of tractor. I tried to remove the 7/8" nut that hold the pulley on but the entire shaft spins so I am unable to remove the pulley. Is the fact that the shaft is spinning...
  5. R

    Muffler won't fit on a predator engine

    Can I use a Briggs & Stratton muffler on a predator engine? Will it affect the operation of the engine if it's a different muffler than the one that was on the engine originally? Thanks Ross
  6. R

    Muffler won't fit on a predator engine

    Predator 212CC LITTLE WONDER WALK BEHIND LEAF BLOWER
  7. R

    Muffler won't fit on a predator engine

    I picked up a predator engine for my leaf blower. Engine's good everything fits except for the muffler. It slams up against the back of the leaf blower housing and there's no way it's going to fit. My question is can I use any muffler on this if I could find one that fits? Or, can I purchase...
  8. R

    Bolens starter

    Have a Bolen's 13AM762f765 38" Lawn Tractor. B&S Engine # 31D707 Type 0232E1. When I turn the key to start it tries to start for a second and then it's as if the starter doesn't engage. Sometimes if I keep trying it will eventually start. If I hook up jumper cables from the car it starts right...
  9. R

    Uphill Battle

    I have a 2005 Bolen's lawn tractor 17.5 HP. It runs smooth & cuts fine as long as I'm on a PERFECTLY flat piece of my land. Any hill at all, and the thing will barely move forward. There a few hills in the lawn which it will barely climb. If I rock back & forth to help it along or go from side...
  10. R

    Loose belt in Ohio

    On to the next possible belt problem. When I go up an incline, whether the blades are engaged or not, I start to lose the ability to climb the hill the engine does not slow down but the it's almost like the tractor it it'll stop actually unless I can turn it so it's going with the incline...
  11. R

    Loose belt in Ohio

    I get it. Without my coffee my brain cells don't wake up till noon. ??
  12. R

    Loose belt in Ohio

    All right thanks StarTech I'm going to try the 38. I don't know where I came up with 69 inch I must have been half asleep when I wrote that I meant 76 inch but you've answered that question already so thanks again I appreciate it.
  13. R

    Loose belt in Ohio

    Sorry, I meant a 69"
  14. R

    Loose belt in Ohio

    Do you guy's think that a 79" would be too small?
Top