Recent content by Freezzman

LMT 4993 some other number 64

should be 18HP Intek plus

Hi Mark Hope this helps Carb Walbro -mexico 0812 696181 Engine Model 31H777 Type 0202 El 0204262A 18HO Intek Plus Family YBSXS.5012VP 274B26 could be a 5

Hi Mark will get the info today And Thanks for Helping

Hi Mark thanks for the video. Unfortunately if I have seen the right video the carb is fine.clicking on the link it was about using a piece of wire from a brush to clean of the jet tree .

B&S Inteck 18hp single cyl hunts seems to run OK for 10 -15 minutes then aggressively hunts . New Gas, tank clean New carb and filter New Plug Checked gas cap for venting (OK) set governor and replaced spring (set Static adj) Ides fine max rpm sounds OK Happens when I use the tractor for lawn...

B&S Inteck 18hp single cyl hunts seems to run OK for 10 -15 minutes then aggressively hunts . New Gas, tank clean New carb and filter New Plug Checked gas cap for venting (OK) set governor and replaced spring (set Static adj) Ides fine max rpm sounds OK Happens when I use the tractor for lawn...

Hi All I was really upset when I found out I coud not install chains on the fron axle of my 445. I came up with this and it works AWESOME front and rear spacers are 3/4 inch.

Hello my 445 front tires hates snow I can only blow snow going straight.Chains wont fit to tire to close to kingpin no clearance. I am going to experiment with some used spindles extending them about 1.5 inches. I will use round stock drilled and tapped. then using a threaded rod or hard bolt to...

Hello I am going to rebuild my 445 it has 700 hours an BURNS oil . everything look straight foreword two questions though. The kit I am looking at has .10 over pistons and rings My guess is ti disassemble and measure. Where do I get cylinder info on final size of bore ? Can I tell if my unit...

Hello All, Excited to be here . JD LX178 JD 445 Polan Pro Frezzman