It looks like the V-twin on my Husquvarna is spraying oil. I'll assume by the location and what I see the crankcase gasket has given way? While I pull the bottom off the engine to replace the gasket, what else should I replace while in there? Are there any exploded views with BOM availble?
Thanks,
I'm not sure if I understand the logic behind your response. Not saying you are incorrect, I just don't understand. Each cylinder seems to run perfectly on it's own. Occasionally the both run great. Compression checks in the past revealed similar numbers. I have not done a check since last...
I've been having an intermittent issue with cylinders cutting out or weak. Here is a typical issue. I start the mower and it has a sputter. If I add choke it smooths out somewhat so I continue to mow. If the choke is off it smells rich. Adding the choke kinda clears it up. So with the engine hot...
Looks like I need p/n 1a646034111 (left axle shaft). Here is my tag and a picture of the shaft. Broke right at the keyway end.
Where can I purchase a shaft? Most internet links are in the UK. I'm in Pennsylvania. Would a local Husqvarna dealer have them?
Thanks,
I broke an axle today. I have not attempted any tear down yet. The axle snapped inside the wheel are. About 1" is sticking out of the housing. I noticed the right wheel did not turn. Is the axle a "posi" or open type with just one wheel turning? Trying to see if I just need one axle or if other...
Yesterday my '08 Husqvarna 2654 had it's initial problem (116 hours). After about an hour of operation I went to back up and I heard a crack and there was no forward or reverse motion. So I push it to the garage to investigate. The drive belt from the engine to the rear axle was off the rear...
I have my buddies Honda HRT216 SDA CGV160 mower that hasn't run for years according to him. I got it running but the hand control really doesn't do much for the engine speed. It will choke and start but the difference between WOT and idle is very minimal. Also as it runs after a few minutes it...