Recent content by darkmann

Thanks for responding. Like I mentioned, I can adjust the bars to “synch” position unpowered (and static). Once powered and moving, mine do not maintain that position - left one stays forward than right one (~3 - 4 inch gap) to maintain straight line operation. I have tried several times to...

Coming from a RZT 50 to a brand new Z2 60 Cub Cadet zero turn mower - bought just last week. I’d rate this new mower 2/5 for now and the primary reason is because I can’t get the lap bars to synch. When static, motor off, I can adjust the bars so they are synched. Once I start the motor, the...

Service and parts diagrams are located on the CobCadet website under https://www.cubcadet.com/en_US/service-and-parts#diagrams, but you have to register your mower to have access. Hopefully that helps.

Thanks. Truly appreciate your help.

Now, that's interesting. A good place to start - relays are relatively inexpensive and it sounds like you experienced my problem last month. Also, a failing relay somewhat envelopes earlier responses from Betrr (switch) and ILENGINE (over temperature). Where's this relay and how hard to...

Seems likely because it never happens when I start cold. Would wet lawn mowing make this worse?

I will check the switch. I had ruled out the switch because the PTO engaged just fine when I start cold and the problem happens only after running for a while, maybe 30 minutes into ride. some times I'll just let it sit for a while and it will work fine. That led me to something overheating...

Mine is a 2010 RZT 50. Recently, after mowing for a short while, when I disengage the PTO, it would not re-engage immediately. I'd have to ride around for a few minutes for it to kick in. For example, if I go into reverse and try to re-engage the PTO going forward, it would not engage...

I have a LT1050 that had been very good over the years. Last week the tranny went and I would like to replace it. I have talked with a couple of repair outfits in my area and it seems like all they want to do is rip me off. I have replaced automotive trannies in the past - those were easy...