Recent content by Chazz11B

I feel your pain. I won't buy another for several reasons

Can you just replace the bearings? I was able to just replace the bearings and installed zerks as well. Saved me hundreds of dollars.

You can add grease zerks. My neighbor helped me do that for my spindles. He also showed me how to remove the bearings from the spindle. Before that I ignorantly/angrily bought an entire spindle. 7.00 vs hundreds.

The OEM vents failed in less than 50hrs. They allowed gas to splash out covering the tanks. I tried several options all of which were not viable. This is what I came up with and it works like a charm. You'll need a hand deburring tool to shave a bit off of the openings. I used a shop-vac...

I've pulled the belt to make sure a pulley isn't seized up. It seems a little hard to pull but not terrible or doesn't seem stuck. It runs If I'm not in the seat.