I am the original owner of my EZR1648 mower. In the last few years the cut has been getting worse and worse. I have replace belts (OEM), blades(OEM and Gator), springs, and bearings trying to get it to mow like it did when it was new. Nothing seems to help. It still leaves stripes in the yard...
Hey all,
I am the original owner of a EZR1648. I think it is the 1st or 2nd year model that came out. Anyways, Here lately it ain't been mowing very well. Don't cut the grass, just knocks it down. or leaves strips on the outside edges of the blades, like they ain't turning fast enough.
I have...
I have a Areins EZR1648 mower. I keep sharp blades on it and good belts. It seems like this year it doesnt mow as good as it use to. The mower is 18 yrs old or so.
It is leaving stripes where blades come together. Grass is knocked down but not cut. What should I check first?
Thanks
Bill
I have a Ariens EZR1648 zero turn mower. Last year I purchased 2 sets of blades for it from a local farm supply store. They are Stens blades. I took the first set off today to sharpen and they are warped. Both ends of all 3 blades raise 1/8 - 3/16 of a inch on each end. I got the second set of...
Is there anywhere I can go to get specs on engines and their parts. I am looking for like line drawings with part sizes and such. Briggs motors.
It would make it a lot easier to figure out what I need if I could see some dimensions.
Here is the deal. I have a JD mower with a Briggs engine. It threw a rod and I am in need of replacing. I purchased a second mower/engine (mower was junk but ran great) to swap out engines. Here is the numbers off of both.
JD
303777-1162-E1 ...... 00112311
Second motor
303777-1125-A1 ...