Recent content by basstracker

can anyone tell me where the ground cable from the battery hooks to the mower. thanks

i need a trans for a kubota t1560 i don't know what other models they put that trans in. thanks

got the new coil today and that fixed the motor it runs great. but now the trans started leaking out the bottom, its about even with where the brake leaver hooks up. looks like some type of vent or something. its about a one inch by 1/2 in and has 2 ribs going across. anyone know anything about...

iv'e tried a couple new plugs, i ordered a new coil yesterday maybe thats it. thanks

thanks for the help, iv'e got the older model so you have to split the trans. i was mowing today and the motor started cutting out and went dead, will not start back up. i checked the spark and its like before spark comes and goes. the motor won't start. i don't know if the new module went out...

hello everyone, i got a new to me kubota t1560. its been setting up for about five years. i cleaned carb and had to put a ignitor module, the 14 hp runs good. after mowing with it the rear end started leaking on the left side. i pulled the wheel off and it hasn't got a seal that you can see.i...

hello everyone, I traded for this mower and I cant get it to freewheel. I found the leaver and pushed it both ways but I still cant push the mower. is there something else you have to do? thanks.

I got a jd 285 and its missing . I put a coil, a plug, a igniter, pulled the valve cover everything is working like it should.checked the compresion its a little low 90. don't know what else to do. please help

i removed the solenoid from the starter and when i put it back on when i try to put the battery cable on the battery the solenoid kicks in.what did i do wrong?

hello everyone, my valves on my kohler engine are ticking part of the time. can you ajust them or not.

need a little help. motor won't do anything when turning the switch. I can cross out the solenoid and it will start up. I can't find the fuses but if the fuse was blown would the motor run? all connections seem to be good.

I have a 6.5 hp push mower, the carb has a flote. I put a new kit in it but it still don't run like it should. i put the seat in with grove facing the bowl,is that right or does it matter. thanks

won't turn past compresson stroke. acts like battery is weak but its not.

Is there anyway to fix a small leak in a plactic gas tank?