Recent content by AgustaEd

afternoon all, I have a T1200 mid 80’s YOM, purchased as a project and for the accessories it came with to stick on my T1600. Engine has been fully overhauled. Has electric start, but no battery present so I haven’t tested the wiring, carb needs a tune and new drive belts, other than that it’s...

Ive posted the question in the other thread with more information. This was purely a hello post.

Well, after a few applications of penetrating spray, some heat, and a destroyed impact driver bit… the bolt is still there. off to the store to get a new impact drive and try again.

One with a 42 inch deck, one with a 36 and one with no deck as it is rusted to hell.

Morning all, just joined the forum after searching tirelessly to no avail about removing an engine on one of my westwood mowers, I have 3, all in different states of (dis)repair. hoping that some knowledgeable folk will be able to steer me right!

I need to remove the engine from a westwood t1200, but I cannot for the life of me get the pulley bolt out of the shaft. The engine just spins and spins, I can’t find any way to prevent it from happening, I’ve tried a ratchet strap around the flywheel. Does anyone have any advice/information on...