Tab Content
  • Regwal's Avatar
    04-23-2017, 09:45 AM
    Regwal replied to a thread PP25 limb saw in Poulan Forum
    Silly me! New carb was supposed to be pre-set so that was last thing I checked. Both needle valves were in closed position. Took some adjusting...
    7 replies | 376 view(s)
  • Regwal's Avatar
    04-22-2017, 09:35 AM
    Regwal replied to a thread PP 42cc chain saw in Poulan Forum
    Found my problem. Saw, like me is old and worn out. Compression was too low to crank. Checked the piston and it was scored pretty good so suspect...
    6 replies | 233 view(s)
  • Regwal's Avatar
    04-22-2017, 09:26 AM
    Clean all terminals for every wire in the start loop. Sounds to me like there is corrosion somewhere. Also jump the safety switches one at a time...
    1 replies | 136 view(s)
  • Regwal's Avatar
    04-16-2017, 11:07 AM
    Regwal replied to a thread PP 42cc chain saw in Poulan Forum
    Kill switch is working. Not sure if coil is working from the way I checked it. With kill switch in "run" checking up to coil there is no...
    6 replies | 233 view(s)
  • Regwal's Avatar
    04-15-2017, 02:27 PM
    Regwal started a thread PP 42cc chain saw in Poulan Forum
    Today I started my saw and used about 1/2 tank cutting grape vines down. I refueled and added chain oil and then saw wouldn't start. After many...
    6 replies | 233 view(s)
No More Results
About Regwal

Basic Information

Me, My Lawn and My Mower
Type of Member:
Homeowner (1-5 acres)
My Location:
Georgia
My Mower:
Husky, Sears, Craftsman, Farmall
Occupation:
retired
Interests:
Traveling by M/C and M/H and retoring Farmall Cubs
Biography:
55 years in Paper Industry in many states and at least 5 countries

Statistics


Total Posts
Total Posts
23
Posts Per Day
0.19
General Information
Last Activity
04-23-2017 09:45 AM
Join Date
12-27-2016
Referrals
0