Tab Content
  • viperv10's Avatar
    08-19-2017, 11:28 PM
    viperv10 replied to a thread Carburetor trouble in Lawn Boy Forum
    Hey guys , here is an interesting story I forgot to tell you. Last week I was talking to the guy I got this R7070 from. He said that when he first...
    22 replies | 885 view(s)
  • viperv10's Avatar
    08-19-2017, 10:44 PM
    viperv10 replied to a thread Carburetor trouble in Lawn Boy Forum
    Oh the sweet smell of success and 2 stroke exhaust. Saturday evening after work I got back to it and put a new coil and spark plug in the old R7070....
    22 replies | 885 view(s)
  • viperv10's Avatar
    08-16-2017, 03:00 AM
    viperv10 replied to a thread Carburetor trouble in Lawn Boy Forum
    Well its been a busy week, lots of overtime and no time to work in the garage. I finally got the engine all put together again and it won't fire up....
    22 replies | 885 view(s)
  • viperv10's Avatar
    08-09-2017, 10:48 PM
    viperv10 replied to a thread Carburetor trouble in Lawn Boy Forum
    Well I put the new rings on and got the piston in and had to go to work. At work I asked a guy who took small engine repair in high school about the...
    22 replies | 885 view(s)
  • viperv10's Avatar
    08-09-2017, 11:56 AM
    I don't see any drawings for your model on the lawn boy site where I always look up parts. I don't think all D series engines take the same coil....
    3 replies | 155 view(s)
  • viperv10's Avatar
    08-08-2017, 04:04 AM
    Welcome to the Lawn Boy forum. This is the place if you need help. There are some really good guys on here that like to help out. My very first Lawn...
    3 replies | 155 view(s)
  • viperv10's Avatar
    08-08-2017, 03:38 AM
    viperv10 replied to a thread Carburetor trouble in Lawn Boy Forum
    Well Phototone you might be on to something. I thought it was screwed in tight when I took it out but I might be wrong. It didn't have spring to hold...
    22 replies | 885 view(s)
  • viperv10's Avatar
    08-04-2017, 01:46 AM
    viperv10 replied to a thread Carburetor trouble in Lawn Boy Forum
    Hey Dixieboy, thanks for your reply. I just put brand new crank seals in. They were Sten's and not OEM but I have used them before and they seemed to...
    22 replies | 885 view(s)
  • viperv10's Avatar
    08-03-2017, 03:29 AM
    viperv10 replied to a thread Carburetor trouble in Lawn Boy Forum
    Well I went ahead and took the case apart. I could not believe how clean the cylinder was inside. No scoring and very little carbon. Just a very...
    22 replies | 885 view(s)
  • viperv10's Avatar
    07-29-2017, 11:44 PM
    viperv10 replied to a thread Carburetor trouble in Lawn Boy Forum
    Well I took the tank shroud off and I had good gas flow out of the tank. The float bowl was full. I cleaned out every little passage in the...
    22 replies | 885 view(s)
  • viperv10's Avatar
    07-25-2017, 03:30 AM
    viperv10 replied to a thread Carburetor trouble in Lawn Boy Forum
    Thanks for your responses. I just checked the compression and it only showed 75. That's awful low. The funny thing is it ran good the couple of times...
    22 replies | 885 view(s)
  • viperv10's Avatar
    07-23-2017, 09:39 PM
    Thanks Rivets, I have some Tecumseh and Walbro parts. Some of the parts look a lot alike. My wife has a long fat needle that I put seats in with to...
    3 replies | 198 view(s)
  • viperv10's Avatar
    07-23-2017, 03:01 PM
    Hi guys, my church has a lawn boy with a Tecumseh engine (silver series 10202). It will start but will not stay running. It will keep running as long...
    3 replies | 198 view(s)
  • viperv10's Avatar
    07-23-2017, 02:48 PM
    Hi guys. I recently picked up a 1980 R7070 model pre compliant mower with a F 100 series engine. It was hard to start, taking at least 20 pulls to...
    22 replies | 885 view(s)
No More Results
About viperv10

Basic Information

Me, My Lawn and My Mower
Type of Member:
Homeowner (1-5 acres)
My Location:
Ohio
My Mower:
LawnBoy

Statistics


Total Posts
Total Posts
64
Posts Per Day
0.20
General Information
Last Activity
Today 03:32 AM
Join Date
10-07-2016
Referrals
0