Tab Content
  • Lawnboy77's Avatar
    Yesterday, 09:01 PM
    Lawnboy77 replied to a thread Gas Leak 10515 in Lawn Boy Forum
    A 10515 is not a Duraforce, it's a self-propelled F series. I think you could be right though in that the needle and seat are not functioning...
    3 replies | 79 view(s)
  • Lawnboy77's Avatar
    Yesterday, 03:35 PM
    Lawnboy77 replied to a thread Gas Leak 10515 in Lawn Boy Forum
    If the valve is working properly then it almost has to be a leaky tank. If the valve is working properly and you close it and run the engine dry...
    3 replies | 79 view(s)
  • Lawnboy77's Avatar
    08-20-2017, 08:56 PM
    Lawnboy77 replied to a thread Magnesium decks? in Lawn Boy Forum
    Just the aluminum plate is different, the engine should be interchangeable. Edit: since the carbs might different between the two engines you may...
    22 replies | 1370 view(s)
  • Lawnboy77's Avatar
    08-20-2017, 05:53 PM
    Man both of those mowers look outstanding, that Krylon Almond looks like a perfect match.
    16 replies | 430 view(s)
  • Lawnboy77's Avatar
    08-20-2017, 05:48 PM
    Lawnboy77 replied to a thread Magnesium decks? in Lawn Boy Forum
    110 psi cylinder compression is good for an F series Lawnboy, but crankcase compression/vacuum would be the more likely issue in my opinion.
    22 replies | 1370 view(s)
  • Lawnboy77's Avatar
    08-20-2017, 03:21 PM
    Lawnboy77 replied to a thread Magnesium decks? in Lawn Boy Forum
    Yes the fuel is drawn up through the nozzle in the carb, but not directly. When the air being drawn through the carb is at a sufficient velocity it...
    22 replies | 1370 view(s)
  • Lawnboy77's Avatar
    08-20-2017, 11:26 AM
    Lawnboy77 replied to a thread Magnesium decks? in Lawn Boy Forum
    Well at this point I think I would check compression, not much else it could be. Sounds like maybe you have enough vacuum to draw the fuel from the...
    22 replies | 1370 view(s)
  • Lawnboy77's Avatar
    08-18-2017, 11:01 PM
    Lawnboy77 replied to a thread Magnesium decks? in Lawn Boy Forum
    Sounds like you are on the right track...I think once you get the fuel supply to the carb bowl up to specs your problem will be solved.
    22 replies | 1370 view(s)
  • Lawnboy77's Avatar
    08-17-2017, 08:50 PM
    Lawnboy77 replied to a thread Magnesium decks? in Lawn Boy Forum
    You say your little 19 mag deck mower is not running, can you elaborate on that? Maybe we can help if we have a bit more info on the symptoms. Model...
    22 replies | 1370 view(s)
  • Lawnboy77's Avatar
    08-01-2017, 02:03 AM
    Lawnboy77 replied to a thread Photobucket in Lawn Boy Forum
    It's not a problem that they started charging for services, but 400 bucks a year is ridiculous.
    26 replies | 1082 view(s)
  • Lawnboy77's Avatar
    07-29-2017, 05:40 PM
    Lawnboy77 replied to a thread 7080 ratio in Lawn Boy Forum
    When you look under the deck just check the opening where the crank extends through the muffler plate (engine mount plate). If yours has the...
    6 replies | 184 view(s)
  • Lawnboy77's Avatar
    07-29-2017, 05:06 PM
    Lawnboy77 replied to a thread 7080 ratio in Lawn Boy Forum
    The extended snout is just the extra cast aluminum that extends down to the bottom of the muffler plate and contains an extra bronze bushing for...
    6 replies | 184 view(s)
  • Lawnboy77's Avatar
    07-29-2017, 03:55 PM
    Lawnboy77 replied to a thread 7080 ratio in Lawn Boy Forum
    It was made in 1970 and 71, should have a D-432 with a 2 ring piston and all-needle bearing connecting rod, so 32 to 1 would be the correct ratio. ...
    6 replies | 184 view(s)
No More Results
About Lawnboy77

Basic Information

Me, My Lawn and My Mower
Type of Member:
Homeowner (under 1 acre)
My Location:
Texas
My Mower:
LawnBoy

Statistics


Total Posts
Total Posts
111
Posts Per Day
0.23
General Information
Last Activity
Today 02:27 AM
Join Date
04-18-2016
Referrals
0