Page 1 of 17 12311 ... LastLast
Threads 1 to 25 of 403

Forum: Build-it Yourself

If you're looking to make your mower better than the factory intended, this is the forum for you...

  1. Sticky Thread Sticky: ZTR Light Kit

    Started by djdicetn, 03-23-2013 12:11 AM
    • Replies: 9
    • Views: 9,549
    07-31-2014, 07:07 PM Go to last post
  1. Motor swap

    Started by guitarpat, 05-19-2017 07:26 PM
    • Replies: 0
    • Views: 96
    05-19-2017, 07:26 PM Go to last post
  2. Engine replacement

    Started by Bill M., 05-15-2017 02:01 PM
    • Replies: 2
    • Views: 157
    05-17-2017, 01:16 PM Go to last post
  3. finally done with my trailer

    Started by RDA.Lawns, 05-08-2017 09:20 PM
    • Replies: 4
    • Views: 270
    05-13-2017, 01:17 PM Go to last post
  4. Front bucket for my JD X324

    Started by rawinok2, 04-20-2017 01:07 PM
    • Replies: 7
    • Views: 453
    04-30-2017, 02:27 PM Go to last post
  5. Dixon adjustment tool

    Started by Tomeverhart, 04-22-2017 06:25 AM
    • Replies: 0
    • Views: 108
    04-22-2017, 06:25 AM Go to last post
  6. Mudding & Hot-Rod Mowers

    Started by Boobala, 04-18-2017 10:12 AM
    • Replies: 8
    • Views: 390
    04-19-2017, 07:46 AM Go to last post
  7. Question Trying to find a tachometer for V-Twin

    Started by mjallen0011, 04-01-2017 10:16 PM
    • Replies: 4
    • Views: 474
    04-18-2017, 08:48 AM Go to last post
  8. Gang of mowers

    Started by dat, 03-01-2017 08:16 PM
    • Replies: 8
    • Views: 721
    03-28-2017, 10:27 AM Go to last post
  9. Running a small engine on kerosene?

    Started by turbofiat124, 11-03-2016 05:50 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 2,320
    03-08-2017, 10:05 PM Go to last post
  10. old black propane mulcher

    Started by peteco, 08-15-2016 08:27 AM
    • Replies: 1
    • Views: 935
    03-08-2017, 05:28 AM Go to last post
  11. The $1 Craftsman

    Started by jakesmurray, 04-18-2016 12:19 PM
    8 Pages
    1 2 3 ... 8
    • Replies: 79
    • Views: 11,462
    03-06-2017, 11:38 PM Go to last post
  12. Home built leaf vacuum

    Started by nicky1, 02-28-2017 07:34 AM
    • Replies: 2
    • Views: 379
    02-28-2017, 09:56 AM Go to last post
  13. PT Trailer Decking - Install Wet or Dry?

    Started by Captain Slow, 02-23-2017 09:41 PM
    • Replies: 2
    • Views: 389
    02-24-2017, 07:46 AM Go to last post
  14. New To Me Trailer Upgrade Ramp Lift

    Started by BlazNT, 02-19-2017 11:06 PM
    • Replies: 4
    • Views: 536
    02-21-2017, 07:26 AM Go to last post
  15. old equipment in a new way

    Started by OleDave, 02-13-2017 03:04 PM
    • Replies: 1
    • Views: 519
    02-14-2017, 06:07 PM Go to last post
    • Replies: 3
    • Views: 1,205
    01-01-2017, 02:35 PM Go to last post
  16. BUILDING A FRONT MOUNT DROP SPREADER

    Started by BWH, 12-11-2016 03:52 PM
    2 Pages
    1 2
    • Replies: 11
    • Views: 1,911
    12-12-2016, 07:49 PM Go to last post
  17. need to drive steel shaft 1"from electric motor and pulley

    Started by greenwing, 12-02-2016 12:23 PM
    2 Pages
    1 2
    • Replies: 15
    • Views: 1,857
    12-04-2016, 05:11 PM Go to last post
  18. Manual crank crankshaft nuts

    Started by turbofiat124, 11-20-2016 07:54 PM
    • Replies: 0
    • Views: 532
    11-20-2016, 07:54 PM Go to last post
  19. Do you believe this?

    Started by turbofiat124, 11-13-2016 07:44 PM
    • Replies: 4
    • Views: 997
    11-20-2016, 07:27 PM Go to last post
  20. Remove reverse cut out sensor?

    Started by Eddles, 11-12-2015 09:29 AM
    2 Pages
    1 2
    advice, blade clutch, blades, children, clutch, company, customers, cut, engine, garden, gear, husqvarna, lawn, move, mower, power, replace, reverse, safety, sensor, spinning, switch, wanted
    • Replies: 12
    • Views: 2,911
    11-07-2016, 08:20 PM Go to last post
  21. Largest replacement 2 cycle engine

    Started by turbofiat124, 11-06-2016 07:13 PM
    • Replies: 2
    • Views: 833
    11-07-2016, 02:29 PM Go to last post
  22. Leaf mulcher suggestion?

    Started by turbofiat124, 06-09-2016 05:26 AM
    • Replies: 6
    • Views: 1,417
    11-03-2016, 09:48 PM Go to last post
  23. Homemade Exhaust System

    Started by mtcjayne, 10-26-2016 01:29 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 2,536
    10-30-2016, 03:12 PM Go to last post
  24. Covered Metal Air Filter Adapted to a Briggs Intek

    Started by ken_clifton, 08-23-2016 10:20 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 2,734
    10-20-2016, 07:51 PM Go to last post

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •